Vortex Edge

The Vortex Edge blade incorporates two features intended to improve blade efficiency during the first half of the drive. The row of features bonded to the back surface of the tip are 'vortex generators' which act on the layer of water near the surface of the blade to decrease drag and increase lift. The blade perimeter tapers in towards the tip. This is to promote vortex development along the blade edges, increasing lift as the angle of attack of the blade increases. For a discussion of the thinking and testing that has gone into the development of the Vortex Edge please read this article.

Who should use the Vortex Edge

Although testing at Concept2 has shown a speed advantage using the Vortex Edge, more testing needs to be done to confirm its universal benefit. To this date there has been no negative response in terms of speed or handling.

Big blade or Smoothie

A Vortex Edge can be used with either of the Concept2 blade styles.

Availability

The Vortex Edge is available on new oars at no additional cost.

Retrofitting your current oars

Adding the tip features and reshaping the blade can be done by anyone who is skilled in oar and boat repair or cutting and finishing composites. Parts will be available from Concept2 at a nominal cost.